Restoration Tile & Grout Cleaner

Restoration Tile & Grout Cleaner – When normal cleaning procedures are not enough, then you have to get tough – and this does the job! This industrial strength acid cleaner will remove embedded mineral deposits and carbonaceous soils such as rust, calcium, urine stains, soap scum, grout haze and efflorescence from manufactured tile and cement grout.

Can be used to etch hard-to-clean grout by removing a super fine layer, leaving your grout sparkling bright and clean. Advanced formulation with premium chemistry and corrosion inhibitors. Not recommended for use on most natural stone.

Available Sizes ▪  1 gal. / 3.8 L bottles

• Item # PC-D405-1
• MFR # 103314
• MFR Legacy # 8.695-085.0
• AKA # D405, CR52GL, 1611-1825, PC-RGC-01, 8036
• GTIN / UPC: 762858730118

Specifications

• Form: Liquid
• pH: 1.5
• Dilution Ratio: Varies 8-32 oz./gal.
  • Light Soil: 8 oz. per gallon of water
  • Medium Soil: 16 oz. per gallon of water
  • Heavy Soil: 32 oz. per gallon of water
• Coverage: Approximately 400 sq. ft. per diluted gallon
• Yield: Makes up to 17 gallons

Features:

• Effective acid cleaner for tile and grout
• Removes embedded soil, mineral deposits, hard water scale from grout
• Safe and more powerful than other tradition acids

Hard Surface

• SDS US English
• Product Label
• Spec Sheet
• Ingredient Disclosure

Directions:

1. Sweep or vacuum to remove dust and loose soil.
2. Dilute between 8 – 32 oz. per gallon depending on the severity of the build-up.
   • Light Soil: 8 oz. per gallon
     
   • Medium Soil: 16 oz. per gallon
   • Heavy Soil: 32 oz. per gallon
3. Apply product with a coarse spray or a mop, allow up to 10 minutes dwell time. Avoid overspray on walls, carpet or furnishings. Agitate with a brush if needed.
4. Clean using truckmount and hard surface cleaning tools, using clear water or Tile and Grout Rinse.
5. Pick up any remaining water with extraction tool or clean terry towels. Dry before allowing traffic.
6. Water-Based Tile and Grout Sealer is recommended after grout it totally dry.

Description:

Restoration Tile & grout is for use on ceramic tile & grout with embedded soil or mineral build-up. DO NOT USE on marble, limestone, or other acid-sensitive surfaces. Always pre-test first. Keep away from metal surfaces, especially chrome or other bright metal surfaces. Pre-test in an inconspicuous location.

CAUTION: Use product only in well-ventilated area. To avoid skin irritation or slip
hazards, do not walk on wet carpets with bare feet.

NOTICE: Product must be stored at room temperature (59°F – 86°F/ 15°C – 30°C). Keep in sealed container when not in use. Product is not warranted if used for repack, improperly stored, or used in a manner not consistent with manufacturer’s instructions.